DiamondFinish Clear
Ask and Answer Questions about DiamondFinish Clear. DiamondFinish Clear is a permanent, high solids, moisture cured single component Clear Coat. DiamondFinish Clear is the latest development in ultra high performance clear coats with very high solids (over 60%) and low VOCs.
Subforums
-
DiamondFinish Clear is a crazy tough Clear Coat that can be applied Direct To Metal or over other coatings. DiamondFinish Clear is a water clear high gloss clear coat that remains permanently flexible and is able to perform in the toughest environments without yellowing, cracking or peeling.
10,330 visits to this link
155 topics in this forum
-
I'm thinking of sealing the barrels (unpolished inner diameter surface) of some chrome wheels. I want to do this to seal the relatively thin chrome coating in this area to protect it from brake dust and sitting water. Here is a picture of the inner barrel of a chrome wheel - in case you are having trouble figuring out what part of the wheel I'm referring to:http://www.calchrome.com/images/ccw_comp_B_back_close.jpg I have several questions for you: Q1: The chrome finish in the barrel area is unpolished and already somewhat rough - but I'm thinking that some additional roughing will make the DiamondFinish adhere better. Will roughing up the chrome improve the adhesion of…
-
- 3 replies
- 3.1k views
-
-
Has DiamondFinish clear coat been tried on plastic headlights successfully? I need a sealer after sanding with 600 and 1000 grit emory. Does it contain a UV?
-
- 1 reply
- 2.4k views
-
-
Can Bloxygen be used to slow down curing of DiamondFinish ClearCoat left in the can? I would like to pour out a working amount, then spray some Bloxygen in the can as I place the lid back on the can? I will use plastic in between the lid and the can to prevent the lid from sticking.
-
- 1 reply
- 2.6k views
-
-
Hi, I have a large warehouse/office and we'd like to do the floors in Diamond Finish White. There's a few support articles on using RustSeal 20% thinned post cleaning with AquaKlean - however can Diamond Finish be applied to clean Concrete directly post prepping?
-
- 1 reply
- 3.6k views
-
-
Hi, I was wanting to know if it was possible and what the procedure would be if so for adding additional coats of Diamond Finish clear coat over fully cured Diamond Finish clear coat. I am wanting to wet sand and polish some imperfections (mainly a bit of orange peel effect) and wanted to add another coat just to help make sure I did not rub through to the base coat, in some cases the panels has been cured for maybe as long as 6 months. What do you recommend. Many Thanks
-
- 1 reply
- 16.6k views
-
