General Questions

Would you recomend any of your products to undercoat my 2001 chevy S10 pick-up? THANKS used your products before with great results!

I just landed here after seeing your article in the new edition of Classic Trucks magazine and I was going to use Rust Bullet, but since seeing your site and what all you offer, I think I just might be going with your product instead. I have a 1970 Chevy Blazer K5 that I am slooowwwly restoring and was wondering if this Trunk & Floorpan kit will be enough to cover the entire insides of the Blazer? I want to do the entire floor inside the truck in the front and in the back and also the rocker panels. I also want to do the inside rear side walls of the bed and inside of the tailgate. Would the quart of product be enough in your opinion to cover everything or would o…

I am looking to do the insides of my 70 Blazer (bedside walls, floor, kickpanels, rocker panels) and was wondering if the Blacktop coating is self leveling or will it leave brush marks? Would the Pre-Val sprayers you offer work for Blacktop, and if so, will it look better than using a brush? I am looking to also use this on my rollbar inside and also my pushbar and tire carrier on the outside of my truck, will this product hold up in the weather and not chip or fade? I will be using the Blacktop coating on top of the RustSeal on this entire project. Thanks for your help.

I have a gas tank that is delaminating at the outer flange on one side, the tank does not have a gap in the flang, but there is rust in the flang, would the gas tank sealer be the best bet (further seperation of the metal is possible because of the rust, although unlikely. Also, is the NuMetal a good product for sealing the flange from the outside?