RustBlast

Im repairing stone chips and small gashes (rips) on the rubberized underseal on a newish car. The chips and rips on the underseal have left spots of rust which I will sand down or wire wheel down to bare metal. After sanding / wheeling this rust, the underseal will have the appearance of dimples or small crevices in the rubber underseal Would it be ok to fix these small patches / holes with Rustseal 3 step process? what would be the best way to ensure the rustseal sticks to the roughed up edges on the rubberized underseal? I want to avoid removing the entire underseal as the small repairs make it impractical, the underseal is v good condition plus the car is not v…

can rust blast be used for getting surface rust off chrome without damaging it? if not do you make anything that does?

Want to use aqua klean and rust blast /seal on classic car wheels that have wooden spokes and split rims. Will products harm wood and tires?

Hello there I have a old steel railing at my home which I had sand blasted and painted over may times but it still rust after some time. What products and methods should I use to clean and paint over the railing so it will not rust for a few years. Thanks

Hi i used rust blast and after cleaning i can see some light rust spots left. should i treat it again or can i use the rust seal over it? thanks

I recently order a motorcycle tank kit. I cleaned the tank out with the Aqua clean and let dry. This actually did a good job and a lot of loose rust was washed out leaving quite a bit of bare metal visible. I then used the rust blast for about 30 minutes. I rinsed it as thouroughly as possibly and let it dry. A rust like coating formed over most of the surfaces even the ones that were clean after the Aqua clean. Some of this can be rubbed off. How should I proceed before using the rust seal? cheers

I have a sandblasted rolling chassie that I got a kit for and since blasted its gotten moisture on it. Do I need to aqua clean it first or will the rust blast and a light scuff be good for the next ster. And can apply the top coat right after or do I have to use rust seal first.