Jump to content
Ordering & InfoSupport ForumSupport DeskContact UsEmail Sign-UpReseller Finder

Which spray gun to use?

Dave G

Recommended Posts

I just purchased two quarts of Blacktop Satin to paint my Jeep frame.  I own three HVLP gravity feed spray guns, and each one has a different fluid tip.  I have 1.4mm, 1.7mm, and 2.0mm.  Which would be the best choice for spraying Blacktop satin, and how much thinning do you suggest?

Link to comment
Share on other sites

It is best to use your 1.4mm tip.


Always use a NIOSH/MSHA approved air supplied respirator. Spray pressure of 35-45 psi (250-330kpa) for siphon/pot guns 25-35psi (170-250kpa) for gravity/top container guns. Thin 5-10% as required. Use only KBS #1 Thinner.


Be sure to check out the Complete Directions for BlackTop Here.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...