Jump to content
Ordering & InfoSupport ForumContact UsReseller FinderFree Catalog

akcevans

Members
  • Content Count

    3
  • Joined

  • Last visited

  1. It was not fusion primer, it was another self etching primer. We have used it in the past on flat surfaces without an issue but the diamond plate has been a challenge. We are applying rust seal in thin coats but perhaps maybe not thin enough. Would I be better off spraying it on with a hvlp gun?
  2. It was new steel so we started off by cleaning it twice with KBS Klean. I know from previous experience that it needs to be perfectly clean to work properly. After cleaning and drying we primed with a self etching primer and waited at least 30 minutes per the instructions on the can. Then we proceeded to apply the rust seal with a brush.
  3. When trying to coat steel tread plate with Rust Seal we are running into a problem where the self leveling properties of the coating prevent the edges of the diamonds from being coated. Is there a trick to this?
×
×
  • Create New...